Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS-system
   8.3. Колодки disk brakes (forward or back)
   8.4. A brake support
   8.5. A brake disk
   8.6. Колодки drum-type brakes
   8.7. The wheel cylinder of brakes
   8.8. The main cylinder of brakes
   8.9. Hoses and hydrodrive tubes
   8.10. Removal of air from a hydrodrive of brakes
   8.11. The vacuum amplifier of brakes
   8.12. Колодки a manual brake of back disk brakes
   8.13. Adjustment of a manual brake
   8.14. A cable of a manual brake
   8.15. The switch of a signal of braking
   8.16. A regulator of pressure of back brakes (dosing out and перепускной the valve)
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


8.4. A brake support
THE GENERAL DATA

The prevention

At serious damages (for example, at подтекании) a support it is recommended to replace liquids. Supports vary in steam on one axis.


Procedure described more low is applicable both to 4-cylinder, and to 1-cylinder supports (these operations are stipulated especially) for lobbies and for back brakes.

Removal, dismantling and installation

PERFORMANCE ORDER
1. Turn away a bolt of the union and disconnect a brake hose.
2. Muffle a hose, having closed apertures of the union a piece of a rubber hose.
3. Slightly drown pistons, turn away fastening bolts (are specified by arrows) and remove a support (subsection 8.3 subitem 6-22 see).
4. Remove a ring of fastening of a cover and a piston cover.
5. Cautiously remove pistons the compressed air.
6. On 4-cylinder supports turn away coupling bolts (are specified by arrows).
7. Remove epiploons.
8. Examine pistons and a surface of cylinders.
9. At detection of damages of a surface (a rust, hollows, scratches, etc.) replace a support and the piston.
10. If a surface in a satisfactory condition get a sealing ring plastic tweezers.
11. On an one-cylinder support beat out from an arm of the plug and remove dustproof covers.
12. Wash out all details a pure brake liquid.
13. Establish in a support rubber rings of pistons and pistons, having dipped them into a brake liquid. The piston should come without a warp under the influence of moderate effort.
14. Establish covers of pistons and blooming rings.
15. On 4-cylinder supports insert into apertures epiploons, having dipped them into a brake liquid, tighten coupling bolts of half of support with the set moment.

The prevention

At assemblage of half track, that epiploons did not drop out of apertures.


16. On an one-cylinder support grease fingers, plugs and apertures in an arm with silicone greasing.
17. Establish covers.
18. Establish a support upside-down.
19. Replace copper linings of the union of a brake hose (are delivered in ремкомплекте).
20. Remove air from a hydrodrive.
21. Before the first departure check up work of brakes.