Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   - 3.4. An engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. The battery
      3.4.3. Power cables
      + 3.4.4. Ignition system
      3.4.5. The ignition coil
      3.4.6. The ignition distributor
      3.4.7. The block of electronic ignition
      3.4.8. The induction gauge
      + 3.4.9. System of a charge of the battery
      3.4.10. The generator
      3.4.11. Generator details
      3.4.12. System of start-up of the engine
      3.4.13. The starter electric motor
      3.4.14. The traction relay of a starter (а/м 1980-87 of release)
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


3.4.10. The generator
THE GENERAL DATA

Details of installation of the generator

1. A hydraulic booster tank
2. An adjusting arm
3. A wire
4. A socket
5. The generator
6. A belt
7. A lock bolt
8. An axis

Removal and installation

PERFORMANCE ORDER
1. To lower the engine and to connect with картером couplings.
2. Disconnect from the generator sockets (are shown by arrows).
3. Loosen the generator bolts (fig. of the Detail of installation of the generator see).
4. Turn on and get adjusting and coupling bolts from an adjusting arm of the generator.
5. Remove the generator and an arm.
6. At acquisition of the new unit grasp with itself the old generator. Be convinced that the new generator in accuracy corresponds to the replaced. Pay attention to conclusions – their number, the sizes and a relative positioning should be same, as on the replaced unit. At last, check up marks. Marks should be or are stamped on the case, or printed on a label and pasted on the case. Be convinced that numbers on new and replaced units coincide.
7. On many new generators there are no pulleys, therefore it is necessary to rearrange a pulley from the replaced unit. At acquisition of the new generator consult concerning pulley installation.
8. Installation is carried out upside-down. Adjust a tension of a belt and check up pressure of a charge.