Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
- 5. Fuel and exhaust systems
   - 5.1. Carburettor engines
      5.1.1. The fuel pump and pressure of fuel
      5.1.2. A gasoline pipe line
      - 5.1.3. A fuel tank Clearing and repair of a fuel tank
      5.1.4. The fuel pump
      5.1.5. The gauge of level of fuel
      5.1.6. The air filter
      5.1.7. A cable of a drive throttle заслонки
      + 5.1.8. The carburettor
      5.1.9. Exhaust system service
   + 5.2. Engines with fuel injection
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

5.1.3. A fuel tank

Fuel tank of cars of series FJ60, FJ62

1. A separator of steams
2. A connector of tubes
3. A stopper
4. A jellied mouth
5. Buffers
6. The gauge of level of fuel
7. A lining
8. A tank
9. Coupling tapes
10. A drain stopper
11. The fuel pump

Fuel tank of cars of series FJ80

1. A ventilating tube
2. A hose
3. A hose of an inlet branch pipe
4. A mouth pipe
5. A stopper
6. An inlet pipe of a mouth
7. A tank
8. A tank guard
9. Coupling tapes
10. A drain stopper
11. A lining
12. An overlay
13. Buffers
14. The pump and the gauge of level of fuel

Removal and installation
The prevention

At performance of works observe fire prevention rules.


The prevention

To remove a fuel tank follows after its full devastation. On some cars in a tank the drain stopper is provided. In the absence of a drain stopper devastate a tank a trip with the subsequent work of the engine idling, or merge gasoline through a hose with the rubber manual pump (is available on sale).

1. Turn away a stopper of a jellied mouth of a tank to remove residual pressure.
2. Disconnect the battery from weight.
3. Merge gasoline.
4. Lift the car and establish on supports.
5. Disconnect from a tank and muffle hoses and tubes.
6. Loosen the a collar also disconnect from a tank a mouth.
7. Turn away a nut and remove a tank guard.
8. Substitute under a tank a prop.
9. Disconnect coupling tapes and take aside.
10. Lower a tank a little and disconnect sockets and a wire on weight.
11. Remove a tank.
12. On a part of cars the additional tank which acts in film precisely in the same order is provided.
13. Installation is carried out upside-down.