Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. A mechanical transmission
   - 7.2. Automatic transmission
      7.2.1. Technical characteristics
      + 7.2.2. Transmission diagnostics
      7.2.3. Draught of the selector of transmission
      7.2.4. System of fixing of the selector
      7.2.5. A drive cable заслонки
      7.2.6. The blocking switch
      7.2.7. Transmission support
      7.2.8. Removal and transmission installation
   + 7.3. A distributing box
   + 7.4. Coupling, карданные shaft, semiaxes and leading bridges
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

7.2.8. Removal and transmission installation


1. Disconnect the battery from weight.
2. Loosen the boats of a casing of the fan.
3. Disconnect a cable заслонки and involve a cable towards transmission.
4. Remove the handle and a cover of the lever of a distributing box.
5. Lift the car and establish on supports.
6. Remove the bottom guard and merge трансмиссионную a liquid from transmission and oil from a distributing box.
7. Remove карданные shaft (cм. Subsection
8. Remove a forward exhaust pipe.
9. Disconnect from картера transmissions a refuelling branch pipe and tubes of a cooler of a liquid.
10. On cars till 1992 disconnect a speedometer cable.
11. Disconnect from transmission sockets and vacuum hoses.
12. Disconnect draughts from transmission () and a distributing box ().
13. Remove a starter.
14. Uncover the hydrotransformer. Designate hydrotransformer position on a leading disk.
15. Turn on serially bolts, turning коленвал.
16. Will hang out the engine and transmission by jacks and turn away bolts of fastening of transmission to a cross-beam.
17. Slightly raise transmission and turn away bolts and nuts of fastening of a cross-beam to a frame and remove a cross-beam.
18. Turn away bolts of fastening of transmission to the engine c left (a photo at the left) and with right (a photo on the right) (are specified by arrows).
19. Displace transmission back and remove from directing pins. Fix the hydrotransformer on transmission. Lower transmission and get from under the car.


1. Be convinced that the hydrotransformer is in gearing with the pump and primary shaft. For this purpose press the hydrotransformer towards transmission, simultaneously turning.
2. Correct landing of the hydrotransformer is accompanied by characteristic sonorous knock.
3. Further assemblage is carried out upside-down.
4. Combine labels on the hydrotransformer, put at dismantling, attach all sockets and hoses.
5. Adjust draughts.