Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. A mechanical transmission
   + 7.2. Automatic transmission
   + 7.3. A distributing box
   - 7.4. Coupling, карданные shaft, semiaxes and leading bridges
      7.4.1. Technical characteristics
      + 7.4.2. Coupling
      - 7.4.3. Cardan () a shaft (), a reducer and axes Check карданных shaft and hinges Removal and installation карданного a shaft Kardannye hinges A blocking nave
      7.4.4. A lobby полуось and an epiploon
      + 7.4.5. The back (forward) bridge
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes Kardannye hinges

Details карданного the hinge

1. A lock ring

2. The bearing

3. Крестовина

4. A plug with a flange


1. Remove propeller a shaft.
2. Clamp a shaft in a vice, designate position of plugs of the hinge and get lock rings of glasses of bearings.
3. Выпрессуйте a bearing glass.
4. For this purpose establish крестовину in a vice through the plug on the one hand and through the mandrel with another.
5. Compress a vice until then while the bearing glass will not appear at the edge of a plug. An alligator wrench or flat-nose pliers get a bearing glass.
6. Rearrange the mandrel and the plug and выпрессуйте an opposite glass.
7. Having removed glasses, carefully clear a plug.
8. Put greasing in new glasses that at assemblage needles were not scattered.
9. Establish крестовину and insert a glass into a plug.
10. Сориентируйте крестовину so that the butterdish direction coincided with a butterdish direction on the opposite end of a shaft (if butterdishes are provided).
11. Insert крестовину into the bearing, insert the opposite bearing.
12. Cautiously, without having damaged epiploons, запрессуйте bearings, having combined them with necks крестовины.
13. Establish rings.
14. If necessary пристукните strong blow on a plug, that steel rings in a place.
15. If rings do not come into flutes disassemble the hinge and check up freedom of rotation of bearings on necks крестовины.
16. Establish propeller a shaft.
17. Grease крестовины (if there are butterdishes).