Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS-system
   8.3. Колодки disk brakes (forward or back)
   8.4. A brake support
   8.5. A brake disk
   8.6. Колодки drum-type brakes
   8.7. The wheel cylinder of brakes
   8.8. The main cylinder of brakes
   8.9. Hoses and hydrodrive tubes
   8.10. Removal of air from a hydrodrive of brakes
   8.11. The vacuum amplifier of brakes
   8.12. Колодки a manual brake of back disk brakes
   8.13. Adjustment of a manual brake
   8.14. A cable of a manual brake
   8.15. The switch of a signal of braking
   8.16. A regulator of pressure of back brakes (dosing out and перепускной the valve)
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


8.9. Hoses and hydrodrive tubes
THE GENERAL DATA

The condition of hoses and tubes is recommended to check each 6 months. At detection of cracks, подтеканий, swellings and other damages a hose replace.

Replacement of hoses of forward brakes

PERFORMANCE ORDER
1. Lift the car and remove a wheel.
2. Turn out the union of a tube from a hose.
3. Get bracket (2) and pass a hose (3) through an aperture in an arm (1 – a tube).
4. Turn away a bolt of the union and disconnect a hose from a support.
5. At assemblage replace copper linings, combine a ledge on a hose with an aperture in a support and tighten a bolt of the union with the set moment.
6. Pass a hose in an arm, screw an union nut, insert bracket and tighten a nut.
7. Remove air from support cylinders (subsection 8.10 see).
8. Establish a wheel and lower the car.

Replacement of hoses of back brakes

PERFORMANCE ORDER
1. Execute actions on subitem 1-3.
2. Remove air from the support cylinder (subsection 8.10 see).

Replacement of tubes

PERFORMANCE ORDER
1. At replacement of tubes track, that on all line they have been fixed by collars.
2. The form of the bent new tubes should correspond to the form of the replaced.
3. Installation only steel tubes, in accuracy corresponding to car mark is supposed.