Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS-system
   8.3. Колодки disk brakes (forward or back)
   8.4. A brake support
   8.5. A brake disk
   8.6. Колодки drum-type brakes
   8.7. The wheel cylinder of brakes
   8.8. The main cylinder of brakes
   8.9. Hoses and hydrodrive tubes
   8.10. Removal of air from a hydrodrive of brakes
   8.11. The vacuum amplifier of brakes
   8.12. Колодки a manual brake of back disk brakes
   8.13. Adjustment of a manual brake
   8.14. A cable of a manual brake
   8.15. The switch of a signal of braking
   8.16. A regulator of pressure of back brakes (dosing out and перепускной the valve)
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


8.5. A brake disk

Check, removal and installation

PERFORMANCE ORDER
1. Release nuts of wheels, lift the car and establish on supports.
2. Remove wheels and wrap nuts of wheels into place to fix a disk concerning a nave (to provide the appendix of effort to a disk, it is possible to dress washers).
3. Release a manual brake.
4. On forward disk brakes remove pads, remove a support, take aside and fix.
5. On back brakes remove a support arm, having turned away bolts.
6. Check up a condition of a disk from both parties. At detection of traces of deep development (depth more than 1,0 mm) remove a disk and прошлифуйте.
7. Check up palpation, having established стрелочный the indicator in 13 mm from disk edge.
8. If palpation on the indicator exceeds norm remove a disk and прошлифуйте.

The prevention

The disk is recommended to be removed and ground periodically on it is dependent on indicator indications. At least it can be made by hand a small skin to reduce a roughness.


9. After polishing the thickness of a disk should not be less maximum permissible which is cast on a disk. On the right value of limiting diameter of a brake drum of a manual brake is specified.
10. Check up a thickness of a disk. Measure a thickness in several places.
11. After checks remove a nave, turn away bolts and remove a disk.
12. At assemblage tighten bolts with the set moment and adjust bearings.

The prevention

On cars till 1990 it is necessary выпрессовать nave hairpins.


13. A back disk remove, having turned away temporarily wrapped up nuts.
14. If the disk does not give in to removal release the adjusting screw of a manual brake and a rubber hammer bring down a disk.
15. At assemblage of forward brakes put greasing and adjust bearings (subsection 2.39 see).
16. Establish a back disk on hairpins, establish an arm of a support and tighten all fastenings with the set moment.
17. Establish pads and antinoise plates.
18. Establish a support and tighten fastening bolts.
19. After assemblage press some times a brake pedal.
20. Check up work of brakes.