Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
- 10. A body
   10.1. Maintenance service and repair
   10.2. Vinyl furnish
   10.3. An upholstery and rugs
   10.4. Repair of insignificant damages
   10.5. Repair of considerable damages
   10.6. Loops and locks
   10.7. A windscreen and motionless glasses
   10.8. A cowl
   10.9. A latch of a cowl and a drive cable
   10.10. A forward lattice
   10.11. A forward wing
   10.12. The internal panel of a door
   10.13. The door lock, the lock and handle switch
   10.14. Door glass
   10.15. Window Lifter
   10.16. Lateral mirrors
   10.17. A door
   10.18. A door of a back compartment
   10.19. A back cover (the top door of a back compartment)
   10.20. A casing of a steering column
   10.21. Panels of forward facing of salon
   10.22. Average floor section
   10.23. The forward facing panel of salon
   10.24. Seats
   10.25. Bumpers
+ 11. An electric equipment
+ 12. Electroschemes


10.1. Maintenance service and repair
THE GENERAL DATA

The condition in which there is a body of your car, is very important, because its cost depends on it in the big degree at resale. It is much more difficult to repair the started or damaged body, than mechanical parts. The latent cavities of a body, such as niches of wheels, a frame and a motor compartment also are important not less in spite of the fact that they do not demand frequent attention, as other parts of a body.

Once a year, or each 20 000 km, the bottom of a body by means of steam is very useful to clear. All traces of a dirt and oil will be removed, and after this area it will be possible to check up on presence of the rust, the damaged brake highways, the worn out electric wires, the damaged ropes and so on. In the end of this work it is necessary to grease components of a forward suspension bracket.

Simultaneously clear the engine and a motor compartment with the help пароочистителя or adaptations for greasing removal.

The special attention is necessary for turning on niches of wheels as the substrate can exfoliate, both stones and a dirt, thrown out by wheels, can damage a paint and allow to appear to a rust. If you have found out a rust, smooth out the damaged surface to the metal and put on it an anticorrosive paint.

It is necessary to wash a body, at least, once a week. Carefully wet the car to soften a dirt, and then смойте it by means of a soft sponge and a considerable quantity of soap water. If carefully not to wash off a dirt, it can erase a paint.

Tar or bitumen stains are necessary for clearing by means of a fabric moistened in solvent.

At least, each six months polish a body and the chromeplated details. If you use a cleaner for the chromeplated parts to remove a rust from details with гальванопокрытием, remember that the cleaner also deletes honour of chrome so use it cautiously.