Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
- 10. A body
   10.1. Maintenance service and repair
   10.2. Vinyl furnish
   10.3. An upholstery and rugs
   10.4. Repair of insignificant damages
   10.5. Repair of considerable damages
   10.6. Loops and locks
   10.7. A windscreen and motionless glasses
   10.8. A cowl
   10.9. A latch of a cowl and a drive cable
   10.10. A forward lattice
   10.11. A forward wing
   10.12. The internal panel of a door
   10.13. The door lock, the lock and handle switch
   10.14. Door glass
   10.15. Window Lifter
   10.16. Lateral mirrors
   10.17. A door
   10.18. A door of a back compartment
   10.19. A back cover (the top door of a back compartment)
   10.20. A casing of a steering column
   10.21. Panels of forward facing of salon
   10.22. Average floor section
   10.23. The forward facing panel of salon
   10.24. Seats
   10.25. Bumpers
+ 11. An electric equipment
+ 12. Electroschemes





10.13. The door lock, the lock and handle switch Cнятие and installation

THE DOOR LOCK

PERFORMANCE ORDER
1. Lift a window, remove the internal panel of a door and a water filter.
2. Working through apertures in a door skeleton, disconnect draughts of the lock from external and internal handles (on cars with the lock electric drive disconnect draught of an electromagnet).
3. All draughts fasten plastic latches. For a draught detachment deduce a latch from gearing with draught and get draught from an aperture.
4. Turn away fastening screws (are specified by arrows) and remove the lock.
5. Installation is carried out upside-down.

THE EXTERNAL HANDLE AND THE LOCK SWITCH

PERFORMANCE ORDER
1. Lift a window, remove the internal panel of a door and a water filter.
2. Working through apertures in a door skeleton, disconnect latches of fastening of draughts of the lock. Access to the external handle is provided through an aperture in a door skeleton.
3. Turn away fastening bolts, get bracket fastenings выклюяателя the lock (or turn away a bolt).
4. Remove the handle in gathering with the lock switch.
5. Installation is carried out upside-down.

THE INTERNAL HANDLE

PERFORMANCE ORDER
1. Remove the internal panel of a door and a water filter.
2. Turn away bolts (are specified by arrows), turn the handle and disconnect from the internal handle of draught of a drive of the lock.
3. Installation is carried out upside-down.