Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
- 11. An electric equipment
   11.1. Search of malfunctions
   11.2. Safety locks
   11.3. Fusible crosspieces
   11.4. Breakers
   11.5. The relay
   11.6. The breaker of indexes of turn / of the alarm system
   11.7. A combination of switches on a steering column
   11.8. The lock of ignition and a lock drum
   11.9. Indexes of level of fuel, pressure and oil temperature
   11.10. A guard of devices
   11.11. The screen wiper electric motor
   11.12. The receiver and dynamics
   11.13. The aerial
   11.14. A heater of back glass
   11.15. Headlights
   11.16. The case halogen headlights
   11.17. A sound signal
   11.18. Replacement of lamps
   11.19. Lateral mirrors with the electric drive
   11.20. Cruise-control system
   11.21. The electric drive window openers
   11.22. The electric drive of door-locks
   11.23. Safety pillows
+ 12. Electroschemes


11.14. A heater of back glass
THE GENERAL DATA

The heater consists from thin проволок, спеченных with a glass surface.

Small destructions проволок can be repaired independently.

Check

PERFORMANCE ORDER
1. Include ignition and a heater.
2. Dress on щуп the voltmeter the combined strip of an aluminium foil and press down a finger to a heater thread.
3. If pressure is equal in the thread centre 6 In the thread is serviceable if pressure is equal 12 In the thread it is torn off (breakage takes place between the centre of a thread and weight). If pressure 0 In the thread is torn off between the centre and feeding conclusion of a heater.
4. If threads are serviceable, connect (-) a conclusion of a heater to weight. If voltmeter indications change, connection with weight the unsatisfactory.
5. The place of breakage of a thread can be established conducting aluminium contact on щупе the voltmeter on a thread aside from (+) a conclusion to (-) to a heater conclusion. (-) a voltmeter conclusion connect to aluminium contact. The voltmeter indication should increase in a place of breakage from 0 to several volt.

Repair

PERFORMANCE ORDER
1. Срастить the torn off thread of a heater it is possible by means of spending эпоксидного structure Dupont N 4817 or equivalent.
2. Disconnect a heater and wait full cooling.
3. A steel sponge cautiously располируйте the damaged site also wipe spirit.
4. Impose on the damaged site a mask from a sticky tape.
5. Prepare pitch, being guided by the instruction.
6. Put structure on a crack in a mask, smearing approximately on 18 mm in both parties.
7. Later 24 hours unmask.