Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. A mechanical transmission
   + 7.2. Automatic transmission
   + 7.3. A distributing box
   - 7.4. Coupling, карданные shaft, semiaxes and leading bridges
      7.4.1. Technical characteristics
      - 7.4.2. Coupling
         7.4.2.1. Coupling details
         7.4.2.2. The vyzhimnoj bearing
         7.4.2.3. The directing bearing
         7.4.2.4. The main cylinder of coupling
         7.4.2.5. The working cylinder of coupling
         7.4.2.6. A coupling hydrodrive
         7.4.2.7. A coupling pedal
      + 7.4.3. Cardan () a shaft (), a reducer and axes
      7.4.4. A lobby полуось and an epiploon
      + 7.4.5. The back (forward) bridge
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


7.4.2.3. The directing bearing
THE GENERAL DATA

The ball directing bearing is a support of a primary shaft of a check point and запрессован in an aperture in a back flange коленвала. A bearing condition it is necessary to check every time when coupling acts in film. If there are doubts concerning a bearing condition it is necessary to replace it. At removal of the engine the bearing varies without fail.

Check and replacement

PERFORMANCE ORDER
1. Remove a transmission.
2. Remove coupling.
3. Wipe greasing and check up a bearing condition, having shined it in an aperture.
4. At detection of damages of a sock of a primary shaft, or in case of the complicated rotation, выпрессуйте the bearing.
5. In the absence of a stripper remove the bearing by means of hydroblow.
6. For this purpose fill deepening in коленвале with dense greasing, carefully having removed air.
7. Strike on the opravke-conductor, inserted into the bearing. Diameter send should be a bit less than internal diameter of the bearing.
8. Get the bearing and remove all greasing.
9. Запрессуйте the new bearing оправкой, resting against an external holder.
10. Establish coupling and a transmission.