Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. A mechanical transmission
   + 7.2. Automatic transmission
   + 7.3. A distributing box
   - 7.4. Coupling, карданные shaft, semiaxes and leading bridges
      7.4.1. Technical characteristics
      - 7.4.2. Coupling
         7.4.2.1. Coupling details
         7.4.2.2. The vyzhimnoj bearing
         7.4.2.3. The directing bearing
         7.4.2.4. The main cylinder of coupling
         7.4.2.5. The working cylinder of coupling
         7.4.2.6. A coupling hydrodrive
         7.4.2.7. A coupling pedal
      + 7.4.3. Cardan () a shaft (), a reducer and axes
      7.4.4. A lobby полуось and an epiploon
      + 7.4.5. The back (forward) bridge
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


7.4.2.4. The main cylinder of coupling
THE GENERAL DATA

Details of the main cylinder of coupling of cars of early releases

1. A washer
2. A tank
3. A pin
4. Шплинт
5. A cover
6. A spring ring
7. A pusher
8. A cup
9. The piston
10. The highway union
11. The cylinder

Details of the main cylinder of coupling of cars of late releases

1. A tank stopper
2. A sealant
3. A spring ring
4. A cover
5. A pin
6. Шплинт
7. A pusher
8. A cup
9. The piston
10. The highway union
11. The cylinder
12. A pin крепелния a tank
13. A tank
14. A float
15. The cylinder in gathering

Dismantling and assemblage

PERFORMANCE ORDER

The prevention

Before dismantling get ремкомплект the cylinder.


1. Disconnect the battery from weight.
2. Disconnect a pusher of the main cylinder from a coupling pedal. For removal of the cylinder of coupling расpinуйте and лостаньте an axis (it is specified by an arrow).
3. Disconnect from the cylinder a hydrodrive highway, merge a liquid and muffle tubes.
4. Turn away a nut and remove the cylinder.
5. Turn away an internal bolt and remove a tank.
6. On cars of late release beat out подпружиненный a pin of fastening of a tank.
7. Remove a cover and a spring ring.
8. Get a pusher, a washer and the piston.
9. Check up a condition of an internal surface of the cylinder. At detection задиров, scratches or the painted sites the cylinder replace.
10. If an internal surface in a good condition replace only уплотнители (are delivered in ремкомплекте).
11. Before installation of their details it is necessary to grease with a brake liquid.
12. Further assemblage is carried out upside-down.

Installation

PERFORMANCE ORDER
Installation is carried out upside-down. Remove air from a hydrodrive.