Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
- 4. Systems of cooling, heating
   4.1. Technical characteristics
   4.2. Antifreeze
   4.3. The thermostat
   4.4. Крыльчатка the fan and гидромуфта
   4.5. A radiator and a broad tank
   4.6. Маслоохладитель
   4.7. The pump of system of cooling
   4.8. The gauge of temperature of a liquid
   4.9. The electric motor and a chain of the fan of a heater
   4.10. A heater radiator
   + 4.11. The control panel a heater and the conditioner
   4.12. A central air and heating
   4.13. Влагоотделитель the conditioner
   4.14. The conditioner compressor
   4.15. The condenser
   4.16. The evaporator and the broad valve
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


4.15. The condenser
THE GENERAL DATA

Bolts of fastening of the condenser

1. A drain hose

2. Скоба the cowl lock

3. A tube with a liquid coolant

4. A collar

Removal and installation

PERFORMANCE ORDER
1. Depressurize the conditioner and remove a coolant in car-care centre.
2. Remove a radiator.
3. Remove a decorative lattice, bracket the lock of a cowl and the central rack.

4. Disconnect a coolant highway on the right side, having turned away a bolt (it is specified by an arrow), muffle щтуцера coolant tubes.
5. Turn away bolts of fastening of the condenser, displace the condenser back and remove from the car.
6. Establish the condenser and arms, wrap bolts.
7. Be convinced of reliability of fastening of rubber pillows on the condenser.
8. Attach coolant tubes, replace ring linings.
9. If the new condenser enter 50 cubic is established see fresh oil of the recommended mark.
10. Other details are established upside-down.
11. Fill the conditioner with a coolant (it is carried out in the same workshop in which depressurization and coolant removal were carried out).