Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
- 4. Systems of cooling, heating
   4.1. Technical characteristics
   4.2. Antifreeze
   4.3. The thermostat
   4.4. Крыльчатка the fan and гидромуфта
   4.5. A radiator and a broad tank
   4.6. Маслоохладитель
   4.7. The pump of system of cooling
   4.8. The gauge of temperature of a liquid
   4.9. The electric motor and a chain of the fan of a heater
   4.10. A heater radiator
   + 4.11. The control panel a heater and the conditioner
   4.12. A central air and heating
   4.13. Влагоотделитель the conditioner
   4.14. The conditioner compressor
   4.15. The condenser
   4.16. The evaporator and the broad valve
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

4.9. The electric motor and a chain of the fan of a heater

The scheme of an electric equipment of air-conditioning of salon

1. The battery
2. The main safety lock
3. An additional safety lock
4. The ignition switch
5. The heater relay
6. The electric motor
7. The resistor
8. The electric motor relay
9. The fan switch
10. The conditioner switch
11. To a rheostat
12. The gauge of pressure of the conditioner
13. Electromagnetic муфта
14. The amplifier
15. The thermoresistor
16. Отсечное the temperature relay

Arrangement of knots of a heater and the conditioner

1. A heater
2. The cooling block
3. The evaporator
4. The broad valve
5. The fan
6, 13. The electric motor
7. The electric motor air заслонки
8. The amplifier
9, 12. The fan resistor
10. The relay of switching of speed
The fan
11. Отсечное the temperature relay
14. A back heater
15, 23. A radiator
16. The thermoresistor
17. The electric motor mixing заслонки
18. The relay of a back heater
19. The switch of a back heater
20. The control panel the conditioner
21. The amplifier of the electric motor mixing заслонки
22. The electric motor of a ventilating nozzle
24. The crane
25. The thermorelay
26. The pressure relay
27. Влагоотделитель
28. The condenser
29. The compressor

Socket of the electric motor of a heater and socket distributing

1. A socket of a forward heater of a series 80

2. A socket of a back heater of a series 80

The block обдува a heater is mounted under the forward panel, or in salon on cars with air-conditioning of a back part of salon.



The prevention

At performance of works on a heater of a part of cars disconnect a safety pillow. For this purpose translate the ignition key in position LOCK, disconnect the battery from weight and start works not earlier than in 2 minutes

1. In default the fan check up a safety lock, a condition of contacts and wires and degree of a charge of the battery.
2. Check up presence of pressure from the battery on an electric motor socket (include ignition and translate the fan handle in position ON).
3. If pressure is not present, there is a wire breakage from the lock of ignition or from the switch.
4. If pressure is present, attach a socket and connect a mass conclusion to weight, having connected a crosspiece from the back party of a socket.
5. If the fan does not join, is possible that the electric motor is faulty.
6. In this case connect electric motor conclusions directly to the battery and weight the wires protected by safety locks.
7. If the electric motor does not join, it is necessary to replace it.
8. If the engine is serviceable, check up the resistor or the switch for what remove the control panel a heater (see subsection 4.11).


1. Disconnect a socket, remove a socket arm, turn away 3 screws and get the block обдува from a casing.
2. Крыльчатку it is possible to remove and establish on the new electric motor.
3. Installation is carried out upside-down.