Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and a steering
   9.1. Technical characteristics
   9.2. The stabilizer of a forward suspension bracket and the plug
   9.3. Forward and back shock-absorbers
   9.4. Springs and plugs
   9.5. Springs of suspension brackets (а/м FJ80)
   9.6. A cross-section bar (а/м FJ80)
   9.7. Suspension bracket levers (а/м FJ80)
   9.8. A rotary fist
   9.9. A steering wheel
   9.10. Steering draughts
   9.11. A reducer
   9.12. The hydraulic booster pump
   9.13. Removal of air from the wheel hydraulic booster
   9.14. Wheels and tyres
   9.15. Corners of installation of forward wheels
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


9.4. Springs and plugs

Check of a condition of plugs

PERFORMANCE ORDER
1. On all cars in springs are established on two plugs, a condition and density запрессовки which periodically it is necessary to check.
2. For this purpose lift the car to remove weight from plugs, and shake a spring eye.
3. At presence люфта it is necessary to replace plugs.

Removal of springs

PERFORMANCE ORDER

The prevention

Described procedure is identical to forward and back plugs. It is recommended to change plugs on each party separately.


1. Lift the car and remove a wheel.
2. Will hang out a jack a bridge beam.
3. Disconnect the bottom fastening of the shock-absorber and take the shock-absorber aside.
4. Turn away a nut of step-ladders, remove a plate and step-ladders.
5. Turn away an earring bolt.
6. Remove a bolt of fastening of a spring to an arm of a frame and remove a spring.

Replacement of plugs

PERFORMANCE ORDER
1. Remove the plug, having rested a screw-driver from within.
2. If necessary moisten a place прилегания eyes and plugs with a getting liquid and sustain time necessary for impregnation.
3. Slightly grease an eye консистентной with greasing and запрессуйте the new plug.

Spring installation

PERFORMANCE ORDER
1. Installation is carried out upside-down.
2. Tighten bolts and nuts with the set moment.
3. Bolts of eyes of a spring tighten under nominal loading of the car.