Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and a steering
   9.1. Technical characteristics
   9.2. The stabilizer of a forward suspension bracket and the plug
   9.3. Forward and back shock-absorbers
   9.4. Springs and plugs
   9.5. Springs of suspension brackets (а/м FJ80)
   9.6. A cross-section bar (а/м FJ80)
   9.7. Suspension bracket levers (а/м FJ80)
   9.8. A rotary fist
   9.9. A steering wheel
   9.10. Steering draughts
   9.11. A reducer
   9.12. The hydraulic booster pump
   9.13. Removal of air from the wheel hydraulic booster
   9.14. Wheels and tyres
   9.15. Corners of installation of forward wheels
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


9.8. A rotary fist
THE GENERAL DATA

Details of a rotary fist
1. A lining
2. The plug
3. A pin
4. A nut
5. The lever
6. The bearing
7. A cover of the case of an epiploon
8. A persistent ring of the case of an epiploon
9. A fist
10. A bolt
11. A bearing cover
12. A remote lining

Removal

PERFORMANCE ORDER
1. Lift car redock.
2. Disconnect from a fist steering draughts.
3. Remove brake details.
4. Remove полуось.
5. Turn away bolts of the case of an epiploon.
6. Turn away a nut of the lever and remove conic washers (are specified by arrows).
7. Remove the top cover of bearings and a remote lining.
8. Remove bearings and designate them ("right top", "right bottom" etc.).
9. Remove the rests of old greasing from bearings, a plug and a fist, having washed out solvent.
10. Check up a condition of bearings, presence on rollers of cracks, выкрашивания and wear tracks. Check up a condition of rings of bearings in plugs. The worn out bearings replace, having removed rings blows on brass оправке. Rings and holders of rollers vary in the complete set.

Installation

PERFORMANCE ORDER
1. Put in holders of bearings refractory greasing, with force having pressed on the bearing so that greasing has come into holder separators.
2. Apply a thin film greasings on the directing.
3. Establish a new epiploon.
4. Establish in a plug the top bearing, insert the bottom bearing.
5. Keeping the bottom bearing, dress a fist on a plug of the bridge and establish a lining and the top cover. Wrap bolts.
6. Establish the lever, conic washers, wrap nuts. Tighten nuts and bolts of covers of the top and bottom bearings with the set moment.
7. Check up a preliminary tightness in bearings. If the moment differs from normal pick up a thickness of remote linings, having removed a part of linings or having established the new.

The prevention

The increase in a thickness of linings reduces a preliminary tightness in bearings, reduction of a thickness leads to tightness increase.


8. Further assemblage is carried out upside-down.