Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   - 3.2. The verhneklapannyj engine 1FZ-FE
      3.2.1. Technical characteristics
      3.2.2. Kinds of repair without engine dismantle
      3.2.3. A cover of a head of cylinders
      3.2.4. A soaking up collector
      3.2.5. A final collector
      3.2.6. Cam-shafts and pushers
      3.2.7. A head of cylinders
      3.2.8. A cover of a chain drive of cam-shafts
      3.2.9. A forward epiploon коленвала
      3.2.10. The oil pallet
      3.2.11. The oil pump
      3.2.12. A flywheel (a leading disk of the hydrotransformer)
      3.2.13. A back epiploon коленвала
      3.2.14. Suspension bracket and engine details
   + 3.3. Dismantle and engine major repairs
   + 3.4. An engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


3.2.14. Suspension bracket and engine details
THE GENERAL DATA

Engine mount details as a rule do not demand leaving, however, at detection of damage of support of the engine, or ageing signs, it is necessary to replace them immediately.

Check

PERFORMANCE ORDER
1. Lift the car and establish on supports, then place under the oil pallet of the engine a support. Lay between the pallet and a support the big board and cautiously raise the engine to unload support. It is forbidden to substitute a board under a drain stopper of the pallet.
2. Check up presence on support of cracks, hardenings or отслоения from a metal basis (the left support – a photo at the left, the right support – a photo on the right).
3. Whether check up plates of support concerning the engine (for this purpose shake support mount, or the big screw-driver) move. If moving is felt, lower the engine and tighten fastenings of support.
4. For ageing delay grease rubber details of support with preserving means.

Replacement

PERFORMANCE ORDER
1. Disconnect the battery from weight, lift the car and establish on supports.
2. For removal of the right support turn on from below nuts and 1 bolt from above, remove from an engine arm the top section of a support.
3. Turn away a nut of fastening of a support to the chassis and remove a support.
4. For removal of the left support turn away a nut and a bolt, separate the bottom and top support.
5. Turn away bolts of pillows of support on the block of cylinders and the chassis, remove support.
6. Installation is carried out upside-down. Grease carvings of nuts and bolts with fixing structure and reliably tighten.