Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
- 5. Fuel and exhaust systems
   + 5.1. Carburettor engines
   - 5.2. Engines with fuel injection
      5.2.1. Technical characteristics
      5.2.2. Декомпрессия fuel system
      + 5.2.3. The fuel pump and pressure of fuel
      5.2.4. Gasoline pipe lines and joints
      5.2.5. The fuel pump
      5.2.6. The gauge of level of fuel
      5.2.7. The air filter
      5.2.8. A cable of a drive throttle заслонки
      - 5.2.9. System of electronic injection of fuel (EFI-system) Check of system of electronic injection of fuel
         - Units of system of electronic injection of fuel
   The case throttle заслонки
   The gauge of an angle of rotation throttle заслонки
   A regulator of pressure of fuel
   The valve of a regulator of turns of idling
   The fuel and atomizer distributor
   The levelling chamber
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes The levelling chamber Removal

The prevention

Works are carried out on the cold engine.

1. Disconnect the battery from weight.
2. Disconnect from the chamber all sockets.
3. Disconnect a drive cable заслонки and draught of transmission.
4. Remove a branch pipe arm маслоуказателя.
5. Accurately designate and disconnect all vacuum hoses.
6. Disconnect a hose of system of ventilation картера.
7. Turn away a bolt and remove an arm (if it is provided).
8. Disconnect and muffle hoses of a cooling liquid.
9. Turn away bolts and remove the chamber.


1. Clear and check up a condition of demountable planes of a collector and the chamber. Replace a lining of the bottom inlet collector. Establish on an inlet collector the chamber in gathering with the case заслонки. Be convinced of correctness of installation of a lining.
2. Wrap fastening bolts to an inlet collector, tighten bolts with the moment specified in (subsection 3.2.1 see). Further installation is carried out upside-down.