Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Kinds of repair without engine dismantle
      3.1.3. Installation of the piston of 1st cylinder in ВМТ
      3.1.4. A cover of a head of cylinders
      3.1.5. A lateral cover of the mechanism timing
      3.1.6. Коромысла and bars of pushers
      3.1.7. Springs of valves, plates, маслосъемные caps
      3.1.8. Soaking up and final collectors
      3.1.9. A head of cylinders
      3.1.10. Pushers
      3.1.11. A pulley коленвала
      3.1.12. A forward epiploon коленвала
      3.1.13. A forward cover
      3.1.14. A cam-shaft and drive gear wheels
      3.1.15. A cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. The oil pallet
      3.1.18. The oil pump
      3.1.19. A flywheel (a leading disk of the hydrotransformer)
      3.1.20. A back epiploon коленвала
      3.1.21. Suspension bracket and engine details
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   + 3.4. An engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


3.1.12. A forward epiploon коленвала
THE GENERAL DATA

The prevention

It is possible to replace an epiploon without removal of a forward cover. However access to an epiploon extends and to work more conveniently if cover to remove.


Replacement of an epiploon without removal of a forward cover

PERFORMANCE ORDER
1. Disconnect the battery from weight. Remove a pulley коленвала (subsection 3.1.11 see).
2. Remember orientation of an epiploon and having hooked, take an epiploon.
3. Slightly grease an external surface and working edges of a new epiploon with oil for the engine and запрессуйте a new epiploon without warps with the help send with a diameter a bit smaller than diameter of an epiploon. The forward surface of an epiploon should be заподлицо with a forward cover.
4. Establish a pulley.

Replacement of an epiploon with cover removal

PERFORMANCE ORDER
1. Remove a forward cover.
2. Hook and get an epiploon. At considerable run of the engine fill in a getting liquid in a backlash between an epiploon and the case and wait time, sufficient for impregnation.
3. Clear an aperture under an epiploon and slightly grease an external surface and working edges of a new epiploon with oil for the engine.
4. Cautiously without warps запрессуйте a new epiploon into place with the help send with a diameter a bit smaller than diameter of an epiploon (a photo at the left) or blows through брусок (a photo on the right).
5. Establish other details upside-down.