Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Kinds of repair without engine dismantle
      3.1.3. Installation of the piston of 1st cylinder in ВМТ
      3.1.4. A cover of a head of cylinders
      3.1.5. A lateral cover of the mechanism timing
      3.1.6. Коромысла and bars of pushers
      3.1.7. Springs of valves, plates, маслосъемные caps
      3.1.8. Soaking up and final collectors
      3.1.9. A head of cylinders
      3.1.10. Pushers
      3.1.11. A pulley коленвала
      3.1.12. A forward epiploon коленвала
      3.1.13. A forward cover
      3.1.14. A cam-shaft and drive gear wheels
      3.1.15. A cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. The oil pallet
      3.1.18. The oil pump
      3.1.19. A flywheel (a leading disk of the hydrotransformer)
      3.1.20. A back epiploon коленвала
      3.1.21. Suspension bracket and engine details
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   + 3.4. An engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


3.1.17. The oil pallet
THE GENERAL DATA

The oil pallet of the engine 3F-E

1. The oil pump
2. The platen of a conducted gear wheel
3. A leading gear wheel
4. A conducted gear wheel
5. Маслоприемник
6. The reduktsionnyj valve
7. A spring
8. Заглушка
9. The oil pallet
10. A drain stopper
11. A lining
12. A final branch pipe
13. The platen of a leading gear wheel

Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Lift car redock.
3. Merge oil and remove the oil filter.
4. Disconnect an exhaust pipe from a collector.
5. Remove a starter and a cover колоколообразного картера.
6. Turn away pallet bolts (fig. the Oil pallet of the engine 3F-E see) and remove the oil pallet. If necessary displace the pallet easy blows of a wooden or rubber hammer.

Installation

PERFORMANCE ORDER
1. Remove from demountable planes of the block of cylinders and the pallet the consolidation rests. Wash out condensed planes solvent.
2. Establish a new lining.
3. Establish the pallet and wrap bolts. Tighten bolts of the pallet with the set moment, beginning an inhaling on corners and continuing in a diagonal order.
4. Further assemblage are carried out upside-down. Fill in oil in the engine and replace the filter. Start the engine and be convinced of absence of leaks.