Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Kinds of repair without engine dismantle
      3.1.3. Installation of the piston of 1st cylinder in ВМТ
      3.1.4. A cover of a head of cylinders
      3.1.5. A lateral cover of the mechanism timing
      3.1.6. Коромысла and bars of pushers
      3.1.7. Springs of valves, plates, маслосъемные caps
      3.1.8. Soaking up and final collectors
      3.1.9. A head of cylinders
      3.1.10. Pushers
      3.1.11. A pulley коленвала
      3.1.12. A forward epiploon коленвала
      3.1.13. A forward cover
      3.1.14. A cam-shaft and drive gear wheels
      3.1.15. A cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. The oil pallet
      3.1.18. The oil pump
      3.1.19. A flywheel (a leading disk of the hydrotransformer)
      3.1.20. A back epiploon коленвала
      3.1.21. Suspension bracket and engine details
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   + 3.4. An engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


3.1.18. The oil pump
THE GENERAL DATA

The prevention

The oil pump is recommended to be changed at each removal of the pallet.

Before drawing a definitive conclusion, check up pressure of oil in greasing system.


Cнятие

PERFORMANCE ORDER
1. Remove the pallet.
2. Turn away 2 bolts of fastening of the pump.
3. Remove the pump with маслоприемником.
4. If the pump is faulty, replace it. This unit is not subject to repair.

Installation

PERFORMANCE ORDER
1. Turn the pump platen so that the groove of the platen (1) has coincided with шлицом a shaft (2) platens of the distributor. The pump should come without effort into place. If the pump does not come, remove it and tighten before coincidence of a groove with шлицом.
2. Further assemblage is carried out upside-down. Fill and start the engine, be convinced of absence of a leak.