Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Kinds of repair without engine dismantle
      3.1.3. Installation of the piston of 1st cylinder in ВМТ
      3.1.4. A cover of a head of cylinders
      3.1.5. A lateral cover of the mechanism timing
      3.1.6. Коромысла and bars of pushers
      3.1.7. Springs of valves, plates, маслосъемные caps
      3.1.8. Soaking up and final collectors
      3.1.9. A head of cylinders
      3.1.10. Pushers
      3.1.11. A pulley коленвала
      3.1.12. A forward epiploon коленвала
      3.1.13. A forward cover
      3.1.14. A cam-shaft and drive gear wheels
      3.1.15. A cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. The oil pallet
      3.1.18. The oil pump
      3.1.19. A flywheel (a leading disk of the hydrotransformer)
      3.1.20. A back epiploon коленвала
      3.1.21. Suspension bracket and engine details
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   + 3.4. An engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


3.1.4. A cover of a head of cylinders

Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight (be convinced that radio tape recorder codes are known).
2. On carburettor engines remove the air filter, on инжекторных remove an air inlet hose, the gauge of speed of a stream and the air filter.
3. Designate and disconnect all hoses and wires which can prevent removal of a cover of a head of cylinders.
4. Turn away bolts of a cover of a head of cylinders, uncover also a lining. If the cover does not give in, displace its blows of a hammer through the soft prorate, or cautiously open consolidation шпателем. It is forbidden to separate a cover, inserting the tool between demountable surfaces.

Installation

PERFORMANCE ORDER
1. Carefully clear condensed surfaces of a cover and a head of cylinders, remove oil traces. Establish a new lining in a cover flute (the lining can to be changed if it has not hardened and on it there are no damages). Replace уплотнители cover bolts.
2. Cautiously establish a cover and wrap bolts.
3. In regular intervals tighten bolts of a cover with the set moment.
4. Establish other details, start the engine and be convinced of absence of a leak.