Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Kinds of repair without engine dismantle
      3.1.3. Installation of the piston of 1st cylinder in ВМТ
      3.1.4. A cover of a head of cylinders
      3.1.5. A lateral cover of the mechanism timing
      3.1.6. Коромысла and bars of pushers
      3.1.7. Springs of valves, plates, маслосъемные caps
      3.1.8. Soaking up and final collectors
      3.1.9. A head of cylinders
      3.1.10. Pushers
      3.1.11. A pulley коленвала
      3.1.12. A forward epiploon коленвала
      3.1.13. A forward cover
      3.1.14. A cam-shaft and drive gear wheels
      3.1.15. A cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. The oil pallet
      3.1.18. The oil pump
      3.1.19. A flywheel (a leading disk of the hydrotransformer)
      3.1.20. A back epiploon коленвала
      3.1.21. Suspension bracket and engine details
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   + 3.4. An engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


3.1.21. Suspension bracket and engine details
THE GENERAL DATA

Engine mount details as a rule do not demand leaving, however, at detection of damage of support of the engine, or their ageing, it is necessary to replace them immediately.

Check

PERFORMANCE ORDER
1. At check the engine should be raised a little to unload support.
2. Lift the car and establish on supports, then place under the oil pallet of the engine a support. Lay between the pallet and a support a board lower the car a little.
3. Check up presence on support of cracks, hardenings or отслоения from a metal basis.
4. Whether check up plates of support concerning the engine or a frame (for this purpose shake support mount, or the big screw-driver) move. If moving lower the engine is felt and tighten fastenings of support.
5. For ageing delay grease rubber details of support with preserving means.

Replacement

PERFORMANCE ORDER
1. Disconnect the battery from weight, lift the car and establish on supports.
2. Turn away a nut of a through bolt of a support.
3. Raise the engine (a jack or талью), get a bolt and remove a support.
4. Installation is carried out upside-down. Grease carvings of nuts and bolts with fixing structure and reliably tighten.