Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Kinds of repair without engine dismantle
      3.1.3. Installation of the piston of 1st cylinder in ВМТ
      3.1.4. A cover of a head of cylinders
      3.1.5. A lateral cover of the mechanism timing
      3.1.6. Коромысла and bars of pushers
      3.1.7. Springs of valves, plates, маслосъемные caps
      3.1.8. Soaking up and final collectors
      3.1.9. A head of cylinders
      3.1.10. Pushers
      3.1.11. A pulley коленвала
      3.1.12. A forward epiploon коленвала
      3.1.13. A forward cover
      3.1.14. A cam-shaft and drive gear wheels
      3.1.15. A cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. The oil pallet
      3.1.18. The oil pump
      3.1.19. A flywheel (a leading disk of the hydrotransformer)
      3.1.20. A back epiploon коленвала
      3.1.21. Suspension bracket and engine details
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   + 3.4. An engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


3.1.13. A forward cover

Removal

PERFORMANCE ORDER
1. Remove a pulley коленвала.
2. Remove the fan (subsection 4.4 see).
3. Remove the compressor of the conditioner and an arm with the generator, take aside.
4. Turn away bolts of fastening of a cover.
5. Cautiously uncover the engine.

Installation

PERFORMANCE ORDER
1. Remove the rests of consolidation and replace an epiploon.
2. Put on a plane of a cover hermetic, establish a cover and wrap bolts.
3. Two bottom bolts wrap on hermetic. In drawing the designation of bolts of a forward cover on the engine 3F-E (subsection 3.1.1 see) is resulted. Grease carvings of bolts And hermetic.
4. Establish a pulley коленвала.
5. Tighten cover bolts.
6. Establish other details upside-down. Start the engine and be convinced of absence of a leak.