1. Lift the car and remove wheels. |
Check of disk brakes |
|
2. Колодки it is possible to check up through a window in a support (it is specified by an arrow). |
3. Measure a thickness of frictional overlays, and if a thickness less specified in subsection 8.1 replace pads. |
4. If there are any doubts concerning a normal state of overlays pads it is necessary to remove. |
5. At the same time measure a thickness of a disk and check up a surface condition (irrespective of its thickness). If the thickness is less than norm a disk replace. Insignificant defects of a surface leave the polishing, strongly worn out disk replace. |
|
6. Check up a hose condition (the check place is specified by an arrow) and tubes of a hydrodrive of brakes. Check up reliability of an inhaling of connections, absence of contact with moving parts. All found out defects immediately eliminate. |
Check of drum-type brakes |
7. Remove drums (subsection 8.6 see). |
|
8. Check up a thickness () frictional overlays. If their thickness (or distance to heads of rivets) is less 1,6 mm, or there are traces замасливания or serious damages pads replace. |
9. Check up a condition of springs and a backlash regulator between колодками and drums. |
|
10. Check up подтекание liquids from the wheel cylinder, having unbent a dustproof cover. At detection of a leak the cylinder replace. |
11. Check up a condition of drums. Minor defects polish a skin, if necessary drums pierce. |
12. Establish all removed details and lower the car. Wheel nuts tighten with the set moment. |