Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
- 2. Maintenance service
   2.1. Additional maintenance service
   2.2. Technical characteristics
   2.3. An arrangement of units in a motor compartment
   2.4. Maintenance service terms
   - 2.5. Check of level of liquids
      2.5.1. Oil level in the engine
      2.5.2. A cooling liquid
      2.5.3. A liquid of a washer of a windscreen
      2.5.4. Electrolit of the storage battery
      2.5.5. A liquid of a hydrodrive of brakes and coupling
   2.6. Check of a condition of tyres and pressure in tyres
   2.7. Liquid level in automatic transmission
   2.8. Liquid level in system of a hydrodrive of a steering
   2.9. Oil replacement in the engine and the oil filter
   2.10. Check of a condition and care of the battery
   2.11. Check of system of cooling
   2.12. Check and replacement of hoses in a motor compartment
   2.13. Check and replacement of brushes of a cleaner of a windscreen
   2.14. Shift of wheels
   2.15. Suspension bracket and steering check
   2.16. Exhaust system check
   2.17. Check of level of oil in a manual transmission
   2.18. Check of level of oil in a distributing box
   2.19. Check of level of oil in reducers of bridges
   2.20. Check of a condition of seat belts
   2.21. The thermostat of the air filter (carburettor engines)
   2.22. Check and greasing of the exhaust valve
   2.23. System of catching of steams of gasoline
   2.24. System check рециркуляции
   2.25. Air заслонка the carburettor
   2.26. A zolotnik of system of ventilation картера
   2.27. Check and replacement of the air filter
   2.28. Replacement of spark plugs
   2.29. Check and adjustment of backlashes of valves
   2.30. Idling turns (carburettor engines)
   2.31. Drive belts
   2.32. Check of fuel system
   + 2.33. Check of brakes
   2.34. Check and adjustment of pedals of coupling (brake)
   2.35. Replacement of the fuel filter
   2.36. High-voltage wires, бегунок and distributor covers
   2.37. Check and installation of the moment of ignition
   2.38. Care of cooling system
   2.39. Naves and bearings of forward wheels
   2.40. Liquid replacement in automatic transmission and the filter
   2.41. Oil replacement in a manual transmission
   2.42. Oil replacement in a distributing box
   2.43. Oil replacement in a back (forward) reducer
   2.44. Backlashes in valves on the engine 1FZ-FE
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


2.5.2. A cooling liquid
THE GENERAL DATA

Broad tank

The broad tank (it is specified by an arrow) the white colour, established behind a radiator, is connected by a hose to the basis of a stopper of a jellied mouth of a radiator.

All cars considered in the given Management, have the closed tight system of cooling of an elevated pressure.

In process of heating of a cooling liquid in an engine operating time there is a replacement of a liquid of a jellied mouth in a broad tank. In process of engine cooling the cooling liquid flows down back in cooling system.

Level of a cooling liquid should be checked regularly. Level should be between marks in tank Full (Full) and Low (Bottom). Depending on temperature of the engine level will vary. On the cold engine, level of a cooling liquid should be a little above mark Low. On the heated-up engine level should coincide with mark Full, or be near to this mark.
PERFORMANCE ORDER
1. If level position does not correspond specified after liquid cooling in a tank remove a stopper and add cooling liquid to mark Full. It is necessary to add only a liquid on a basis этиленгликоля and waters, it is forbidden to add anticorrosive additives independently. The recommended structure of a liquid in cooling system is specified in the car maintenance instruction.
2. If it is necessary to turn out a stopper of a jellied mouth of a radiator wait full cooling of system, then wrap up a stopper a thick layer of rags and turn it to the first emphasis. At steam occurrence wait while the liquid will cool down completely, then turn out a stopper.
3. At check of level of a liquid always watch its condition. It should be concerning transparent. If the liquid has got brown colour, or colour of a rust it is necessary to replace it, preliminary having washed out cooling system. Anticorrosive properties are exhausted in due course, though the liquid and can keep satisfactory appearance.
4. Do not suppose antifreeze hit on a skin or on the painted surfaces of the car. In case of hit immediately wash out their considerable quantity of water.
5. If after a short time interval after доливания liquid level goes down, infringement of tightness of system is possible. Check up a radiator, hoses, a stopper of a jellied mouth, an inhaling of drain stoppers, and the water pump. If obvious signs of a leak it is not revealed, check up a radiator stopper, having handed over it in a car-care centre workshop.